Proxy environment variables

curl checks for the existence of specially named environment variables before it runs to see if a proxy is requested to get used.

You specify the proxy by setting a variable named [scheme]_proxy to hold the proxy hostname (the same way you would specify the host with -x). If you want to tell curl to use a proxy when access an HTTP server, you set the http_proxy environment variable. Like this:

curl -v

While the above example shows HTTP, you can, of course, also set ftp_proxy, https_proxy, and so on. All these proxy environment variable names except http_proxy can also be specified in uppercase, like HTTPS_PROXY.

To set a single variable that controls all protocols, the ALL_PROXY exists. If a specific protocol variable one exists, such a one takes precedence.

No proxy

You sometimes end up in a situation where one or a few hostnames should be excluded from going through the proxy that normally would be used. This is then done with the NO_PROXY variable. Set that to a comma- separated list of hostnames that should not use a proxy when being accessed. You can set NO_PROXY to be a single asterisk ('*') to match all hosts.

If a name in the exclusion list starts with a dot (.), then the name matches that entire domain. For example matches both and but not

As an alternative to the NO_PROXY variable, there is also a --noproxy command line option that serves the same purpose and works the same way.

Since curl 7.86.0, a user can exclude an IP network using the CIDR notation: append a slash and number of bits to an IP address to specify the bit size of the network to match. For example, match the entire 16 bit network starting with 192.168 by providing the pattern

http_proxy in lower case only

The HTTP version of the proxy environment variables is treated differently than the others. It is only accepted in its lower case version because of the CGI protocol, which lets users run scripts in a server when invoked by an HTTP server. When a CGI script is invoked by a server, it automatically creates environment variables for the script based on the incoming headers in the request. Those environment variables are prefixed with uppercase HTTP_.

An incoming request to an HTTP server using a request header like Proxy: yada therefore creates the environment variable HTTP_PROXY set to contain yada before the CGI script is started. If such a CGI script runs curl, it is important that curl does not treat that as a proxy to use.

Accepting the upper case version of this environment variable has been the source for many security problems in lots of software through times.